Weathertech Tonneau Cover Installation
Weathertech Tonneau Cover Installation. Orientate clamp halves so long legs are towards bottom. Even one person can easily handle that.
Removal and reinstall of cover a. Repeat for tension adjuster (“r”) on passenger side of Installation is easy with no need to drill into the truck bed;
Even One Person Can Easily Handle That.
It knows the weather protection, which may indicate your desire to select the product. With cover completely open and storage clips secured, pull synthetic cord on front panel and lift rear of cover up 1 above rails (figure 1). Installation is easy with no need to drill into the truck bed;
Slide Cover Back To Disengage Hooks Then Lift To Remove (Figure 2).
The aluminum construction that are used to hold the panels can carry a lot of weight. Install clamp at each shim location. The weathertech® roll up truck bed cover is water resistant, featuring front and rear seals that form a tight barrier between the truck and cover, as well as the hook and latch fastening side seals.
Moreover, I Am Telling You Not To Worry About The Installation.
Tension is changed with a grip tension adjuster. Now comes the installation part. Hold rear edge of folded cover
The Installation Manual For Good Products Is Accompanied By Graphical Illustrations.
Well, if you go through the installation manual, you will find it pretty comprehensive. This cover also provides the security of the vehicles. Place leading edge of front panel on rails at front of box.
Repeat For Tension Adjuster (“R”) On Passenger Side Of
Removal and reinstall of cover a. For kits with 8 total clamps, install 4th clamp between 2nd and 3rd clamps on each side. The storage clips secure the truck bed cover from falling off under the rough conditions.easy installation.
Post a Comment for "Weathertech Tonneau Cover Installation"